We start with a .035" Under Sized Bore Block. The block is then matched up with a side cover and line bored with a EZ-Bore machine, honed with a Sunnen Hone to .002" piston clarence.
The block is not decked so the piston will be about .030" in the hole.
This comes with a standard piston that was used to size the piston clarence & crank shaft (std or max stroke) Options can be picked at the bottom of the page on the right-hand side.
Heat cycling of the block helps to prevent the shifting of the cylinder bore once it is run.
We also offer these options on the block, decked and heat cycled. Options can be picked at the bottom of the page on the right-hand side.
We have sold a lot of these blocks to majar engine builders.